In 6G telecom research today, a crucial portion of wireless spectrum has been neglected: the Frequency Range 3, or FR3, band. The shortcoming is partly due to a lack of viable software and hardware platforms for studying this region of spectrum, ranging from approximately 6 to 24 gigahertz. But a new, open-source wireless research kit is changing that equation. And research conducted using that kit, presented last week at a leading industry conference, offers proof of viability of this spectrum band for future 6G networks. In fact, it’s also arguably signaling a moment of telecom industry re-evaluation. The high-bandwidth 6G future, according to these folks, may not be entirely centered around difficult millimeter wave-based technologies. Instead, 6G may leave plenty of room for higher-bandwidth microwave spectrum tech that is ultimately more familiar and accessible. The FR3 band is a region of microwave spectrum just shy of millimeter-wave frequencies (30 to 300 GHz). FR3 is also already very popular today for satellite Internet and military communications. For future 5G and 6G networks to share the FR3 band with incumbent players would require telecom networks nimble enough to perform regular, rapid-response spectrum-hopping. Yet spectrum-hopping might still be an easier problem to solve than those posed by the inherent physical shortcomings of some portions of millimeter-wave spectrum—shortcomings that include limited range, poor penetration, line-of-sight operations, higher power requirements, and susceptibility to weather. Pi-Radio’s New Face Earlier this year, the Brooklyn, N.Y.-based startup Pi-Radio—a spinoff from New York University’s Tandon School of Engineering—released a wireless spectrum hardware and software kit for telecom research and development. Pi-Radio’s FR-3 is a software-defined radio system developed for the FR3 band specifically, says company co-founder Sundeep Rangan. “Software-defined radio is basically a programmable platform to experiment and build any type of wireless technology,” says Rangan, who is also the associate director of NYU Wireless. “In the early stages when developing systems, all researchers need these.” For instance, the Pi-Radio team presented one new research finding that infers direction to an FR3 antenna from measurements taken by a mobile Pi-Radio receiver—presented at the IEEE Signal Processing Society‘s Asilomar Conference on Signals, Systems and Computers in Pacific Grove, Calif. on 30 October. According to Pi-Radio co-founder Marco Mezzavilla, who’s also an associate professor at the Polytechnic University of Milan, the early-stage FR3 research that the team presented at Asilomar will enable researchers “to capture [signal] propagation in these frequencies and will allow us to characterize it, understand it, and model it... And this is the first stepping stone towards designing future wireless systems at these frequencies.” There’s a good reason researchers have recently rediscovered FR3, says Paolo Testolina, postdoctoral research fellow at Northeastern University’s Institute for the Wireless Internet of Things unaffiliated with the current research effort. “The current scarcity of spectrum for communications is driving operators and researchers to look in this band, where they believe it is possible to coexist with the current incumbents,” he says. “Spectrum sharing will be key in this band.” Rangan notes that the work on which Pi-Radio was built has been published earlier this year both on the more foundational aspects of building networks in the FR3 band as well as the specific implementation of Pi-Radio’s unique, frequency-hopping research platform for future wireless networks. (Both papers were published in IEEE journals.) “If you have frequency hopping, that means you can get systems that are resilient to blockage,” Rangan says. “But even, potentially, if it was attacked or compromised in any other way, this could actually open up a new type of dimension that we typically haven’t had in the cellular infrastructure.” The frequency-hopping that FR3 requires for wireless communications, in other words, could introduce a layer of hack-proofing that might potentially strengthen the overall network. Complement, Not Replacement The Pi-Radio team stresses, however, that FR3 would not supplant or supersede other new segments of wireless spectrum. There are, for instance, millimeter wave 5G deployments already underway today that will no doubt expand in scope and performance into the 6G future. That said, the ways that FR3 expand future 5G and 6G spectrum usage is an entirely unwritten chapter: Whether FR3 as a wireless spectrum band fizzles, or takes off, or finds a comfortable place somewhere in between depends in part on how it’s researched and developed now, the Pi-Radio team says. “We’re at this tipping point where researchers and academics actually are empowered by the combination of this cutting-edge hardware with open-source software,” Mezzavilla says. “And that will enable the testing of new features for communications in these new frequency bands.” By contrast, millimeter-wave 5G and 6G research has to date been bolstered, the team says, by the presence of a wide range of millimeter-wave software-defined radio (SDR) systems and other research platforms. “Companies like Qualcomm, Samsung, Nokia, they actually had excellent millimeter wave development platforms,” Rangan says. “But they were in-house. And the effort it took to build one—an SDR at a university lab—was sort of insurmountable.” So releasing an inexpensive open-source SDR in the FR3 band, Mezzavilla says, could jump start a whole new wave of 6G research. “This is just the starting point,” Mezzavilla says. “From now on we’re going to build new features—new reference signals, new radio resource control signals, near-field operations... We’re ready to ship these yellow boxes to other academics around the world to test new features and test them quickly, before 6G is even remotely near us.”

View Entire Post